In the below series of images, I have shown the clockwise movement of motor.Now I have added four states in the circuit, when I make any state one that stator got magnetize and the motor rotor will attract towards that stator and start moving. This circuit is just for understanding purposes.Now design the circuit as shown in the below figure:. First of all, add the below two components from the Proteus library in the workspace.Stepper Motor Drive Circuit in Proteus ISIS These electromagnets act as a stater and when one side get magnetize, it attracts the rotor towards it and then we need to magnetize the other side and demagnetize the previous one and in this ways if the sequence is right the motor starts moving. In stepper motor, there are electromagnets which gets polarized when we supply voltage to them and depolarized when we remove the voltage. Today we will have a look on the 6 wired stepper motor. Mostly stepper motors use 6 wires to control them but few of them also have 4 wires to control them. Stepper motors are usually of two types and the main difference between the two is in the number of wires used to control them. In the last post we have seen How to control DC motor in Proteus, and now we are gonna see How to design a Stepper Motor Drive Circuit in Proteus ISIS. Today's topic is about the control of stepper motor. Hello friends, hope you all are healthy, wealthy and wise.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |